ERG600W Pre-Assembly Pack Checklist
ERG600W Step-by-Step Assembly Instructions
1. Rear Stabilizer
a. Turn over the Slide Rail (3) as above. Attach the Rear Stabilizer (4) to the Slide Rail with four Washers (#71) and four Outer Hex Screws (#66).
b. Tighten with Spanner (#75).
2. Front Stabilizer Endcaps
a. Attach left & right End Caps (25, 26) to Front Stabilizer (2). Then tighten with two Cross Screws (#68) using the Spanner (#75).
3. Attaching the Front Stabilizer
a. Turn the Main Frame (1) upright. Attach the Front Stabilizer (2) to Main Frame (1) using eight Washers (#71) and eight Screws (#60). Tighten with Allen Wrench (#74).
b. You can put 3~4 screws into the holes first, and start tightening by hand. After all the screws are put in, then tighten with the tool.
4. Seat and Rail
a. Slide the Seat (36) onto the Slide Rail (3).
b. Attach the Slide Rail (3) to the Main Frame (1) using four Flat Screws (58).
c. Secure the Stopper (35) with two Screws (#60) and Washers (#87). Insert all six screws partially into the holes first, and then tighten with Allen Wrench (#74).
d. Attach the left Rail Endcap (82) and right Rail Endcap (83) to the Slide Rail (3).
5. Console
a. Attach Console (46) to Main Frame (1) using four Washers (#71) and four Screws (#60). Tighten with Allen wrench (#74).