ERG650W Pre-Assembly Pack Checklist
ERG650W Step-by-Step Assembly Instructions
1. Slide Rails and Rear Stabilizer
a. Turn over the Slide Rail (3) as above. Attach the Seat’s Rollers (39) to the Slide Rail making sure the plate touches the rollers. To secure the Slide Rails between the Rollers, you’ll need to insert it at an angle and rotate as shown above.
b. Secure the Rear Stabilizer (2) to the Slide Rails (3) using two Screws (#74) and two Washers (#63) on both sides.
2. Connecting the Slide Rail to the Main Body
a. Standing the Main Frame (1), attach the Slide Rail (3). Tighten using four Long Screws (#99) on the “top” or seat side of Frame, two Medium Screws (#77) on the “outer sides” of the Frame, and six Short Screws (#65) along the “bottom” and “inner side” of the Frame.
3. Attaching the Console
a. Place 2 AA batteries into the Console (54).
b. Turn the Main Frame (1) upright. Connect the Sensor Wire (56) to the Connection Wire (96). Be careful not to pinch the wires. Feed any extra length of wire to lay in the Main Frame.
c. Plug the Decorative Cover (26) into the Main Frame (1).
d. Secure the Console (54) to the Main Frame using four Small Screws (#68).