Skip to main content

Operating Your AIR350

Erika Gardner
  • Updated

mceclip0.png

Console Set-Up

Battery Installation

After completing assembly of your air bike, ensure that the console is operational by installing the 2 AA batteries (included). Install the batteries by opening the battery compartment located on the back side of the console.

Console Buttons

MODE: Press to select functions. Press and hold for two (2) seconds to reset all functions to zero (0), except the odometer. 

SET: While in STOP mode, press SET to set target values for time, calories, and distance. Press SET and hold for two seconds. The value will increase automatically even if you are not holding the SET button. Press any button to stop. 

RESET: While in STOP mode, press the button to reset the setting values to zero. Press the RESET button and hold for two (2) seconds to reset all functions to zero, except odometer.

Functions and Operations

Note: The console display will automatically shut off is there is no signal received after four (4) minutes of inactivity. If the machine's console display is faint or shows no figures, please replace the batteries.

SCAN: Press and hold the MODE button until “SCAN” appears on display. The console will display TIME, CALORIES, ODOMETER, SPEED, and DISTANCE in a sequence for six (6) seconds at a time. 

TIME: Displays the time elapsed or can count down from preset value. 

CALORIES: Displays the calories burned or can count down from preset value. 

A note about your console’s calorie display: Your console’s calorie display is to be used as a reference only to monitor improvement from workout to workout. No exercise machine can give you an exact calorie count because there are too many factors which determine exact calorie burn for any particular person. Even if someone is the exact same body weight, age and height, their calorie burn may be very different from yours.

ODOMETER: Displays the total accumulated distance you have traveled from the first time of use. The odometer does not reset unless you remove the batteries. 

SPEED: Displays the user's current speed. 

DISTANCE: Displays distance traveled during current exercise session or can count down from preset value.

Countdown Function

You can preset values to countdown the desired TIME, CALORIES or DISTANCE. To set:

  1. Press MODE until the function you want is displayed. Make sure meter is not in SCAN.
  2. Press SET to increase the value. If you press SET and hold for a few seconds, the value will increase automatically.
  3. Press any key to stop at a value.

Related articles