Pre-Assembly
MBX2500 Assembly Pack Checklist
Assembly
MBX2500 Step-by-Step Assembly Instructions
1. Installing the Console Battery
a. Press against the clip on the battery cover to remove it.
b. Install the included CR2032 3V battery by tilting the battery slightly to its side and slide it in (positive side facing up, negative side facing down).
c. In the event that you need to replace the battery, after opening the battery cover, gently hold the black clip on the side and the battery will pop out. A set of tweezers may be helpful.
2. Stabilizers
Hardware Needed for This Step | |
#3 | Carriage Bolts (4 pcs) |
#5 | Curved Washers (4 pcs) |
#6 | Domed Nuts (4 pcs) |
a. Attach the front stabilizer (15) to the main frame (16). Secure using two carriage bolts (#3), two curved washers (#5) and two domed nuts (#6).
b. Attach the rear stabilizer (4) to the main frame (16). Secure using two carriage bolts (#3), two curved washers (#5) and two domed nuts (#6).
3. Seat Post
Hardware Needed for This Step | |
#7 | Ball Type Quick Release Knob (1 pc) |
a. Loosen the nuts on the under side of seat (13), place the seat (13) onto seat post and then retighten the nuts.
b. Insert the seat post (10) into the Main frame (16). Secure using the ball type quick release knob (#7).
4. Handlebars and Console
Hardware Needed for This Step | |
#19 | L Type Quick Release Knob (1 pc) |
#22 | Ball Type Quick Release Knob (1 pc) |
#73 | Screws (4 pcs pre-assembled) |
a. Insert the battery into console.
b. Insert the handlebar post (17) to the main frame (16). Secure using an L type quick release knob (19).
c. Attach the handlebar (18) to the handlebar post (17). Secure using a ball type knob (22).
d. Attach computer (72) onto the computer bracket and secure using 4 screws (73) which are pre-assembled on the backside of computer (72). Attach sensor wire (74) to computer (72).
5. Pedals
a. Attach the left pedal (1L) to the left crank (33).
b. Attach the right pedal (1R) to the right crank (36).
Before Using
Before operating your MBX2500, please do the following:
- Tighten all bolts/nuts securely to complete your installation.
- Adjust all four levelers so your unit sits flat on the ground for a stable ride. If placing on a mat or on carpet, then it may take time for your unit to settle into the floor padding and will not feel as stable as if placed on a hard surface.
- Make sure to tighten both pedals securely to the pedal crank arms as instructed.
- Once proper seat and handlebar height is selected, make sure to tighten securely for a solid feel.