Pre-Assembly
FB160 Assembly Pack Checklist
Note: The above parts are all needed to assemble this machine. Before you start to assemble, please check the hardware packing to make sure all pieces are included. Some of the parts for this machine are preassembled on the unit. Please read all instructions to ensure there is no confusion.
FB160 Assembly Part Checklist
Assembly
FB160 Step-by-Step Assembly Instructions
1. Front Stabilizer and Rear Stabilizer
Hardware Needed for This Step | |
#73 | Wrench |
a. Pull out the Lock Pin (No. 11) from the Front Support Tube (No. 01) and adjust the Front Support Tube (No. 01) to the open position then re-insert the Lock Pin (No. 11) to secure the frame position.
b. Attach the Front Stabilizer (has wheels) (No. 05) to the Front Support Tube (No. 01), tighten with the pre-installed 2 Curved Washers (No.13) and 2 Domed Nuts (No. 14).
c. Repeat the procedure for the Rear Stabilizer (No. 06).
2. Pedals
Hardware Needed for This Step | |
#73 | Wrench |
a. Connect the Left Pedal Strap (L) to the Left Pedal (No. 09L). Adjust the pedal strap to the length you need. Assemble the Right Pedal Strap (R) to the Right Pedal (No. 09R) in the same way.
b. Connect the Left and Right Pedal (No. 09L & 09R) to their appropriate Crank (No. 15L & 15R). The right pedal is on the right hand side of the bike as you sit on it. The Right Pedal (No. 09R) should be tightened clockwise and the Left Pedal (No. 09L) counter-clockwise. The left pedal should turn towards the front of the machine (counterclockwise) when screwing them on.
3. Seat
Hardware Needed for This Step | |
#10 | Club Knob |
#73 | Wrench |
a. Remove the preinstalled 3 Flat Washers (No. 16) and 3 Nylon Nuts (No. 17) from the back of Seat (No. 07) (see fig. 3.1). Attach the Seat (No. 07) to the Seat Support Tube (No. 03), using the preinstalled 3 Flat Washers (No.16) and 3 Nylon Nuts (No. 17).
b. Insert the Seat Support Tube (No. 03) to the Front Support Tube (No. 01); fasten with the Club Knob (No. 10).
4. Handlebar
Hardware Needed for This Step | |
#72 | Allen Key |
a. Remove 4 Screw Sets (No. 12) from the Handlebar Tube (No. 04).
b. Connect the Middle Sensor Wire (No. 19) with the Console (No. 08).
c. Attach the Handlebar Tube (No. 04) to the Rear Support Tube (No. 02), and tighten with 4 Screw Sets (No. 12).