Skip to main content

TRX1400 Pre-Assembly and Assembly

Erika Gardner
  • Updated

TRX1400 Assembly Pack Checklist

  • Combination M5 Allen Wrench & Phillips Head Screwdriver
  • 1 Main Frame
  • 2 Uprights
  • 2 Frame Base Covers
  • 1 Console
  • 1 Deck
  • 1 Power Cord
  • 1 Lubricant
  • 1 Hardware Kit

TRX1400 Pre-Assembly Procedure

WARNING: There is a Velcro strap installed around the treadmill base that prevents the unit from unfolding accidentally during shipping. If this strap is not removed properly, the treadmill could spring open unexpectedly and cause injury if someone is standing near the unit when the strap is removed.

To ensure your personal safety during removal of the shipping strap please make sure the treadmill is positioned flat on the ground, in the orientation it would be in if you were using the treadmill. Do not turn the treadmill up on its side while removing the shipping strap. This could cause the unit’s folding mechanism to spring open. If the end of the Velcro strap (that you need to grab to remove it) happens to be under the treadmill deck, reach under the deck to grab it, but do not tilt the treadmill up to gain access to the strap end.

  1. Cut the straps, then lift the box over the unit and unpack. Carefully remove all parts from the carton and inspect for any damage or missing parts. If parts are damaged or missing, contact your dealer immediately.
  2. Locate the hardware package. Remove the tools first.
  3. Remove the hardware for each step as needed to avoid confusion. The numbers in the instructions that are in parenthesis (#) are the item number from the assembly drawing for reference.

TRX1400 Assembly Steps

  1. Take out the treadmill from the carton and lay it aside on the smooth ground.
  2. Connect the Computer Cable (Middle, 47) with the Computer Cable (Lower, 45).
  3. Insert the Uprights (L3,L4) into the Frame Base (2) with the 6pcs of 5/16” × 1/2” Button Head Socket Bolts (94), 4pcs of Ø5/16” × Ø18 × 1.5T Flat Washers (79) and 2pcs of Ø8 × Ø23 × 1.5T Curved Washers (95) by using the Combination M5 Allen Wrench & Phillips Head Screw Driver (104). Attach the screw without tightening it completely.

  4. Connect the Computer Cable (Upper, 46) with the Computer Cable (Middle, 47).
  5. Install the Console Support (5) into the Uprights (L3, L4) with the 4pcs of 5/16” × 1/2” Button Head Socket Bolts (94) and 4pcs of Ø8 × Ø23 × 1.5T Curved Washers (95) by using the Combination M5 Allen Wrench & Phillips Head Screw Driver (104).
  6. Install the left and right Frame Base Covers (24, 25) on the frame base and the uprights respectively fix by tightening 4pcs of M5 × 15m/m Phillips Head Screws (83) with Combination M5 Allen Wrench & Phillips Head Screw Driver (104).
NOTE: Please tighten all screws after all components assembly is complete.

Powering On

Power the unit on by plugging it into an appropriate wall outlet, then turn on the power switch located at the front of the treadmill below the motor hood, Ensure that the Safety Key is installed, as the treadmill will not power on without it. When the power is turned on, all the lights on the display will light up for a short time and the console will show the software version. The treadmill will then enter idle mode, which is the starting point for operation.

Related articles